MIMAKI JV4 Series, Руководство по эксплуатации

Страница: 89 / 152

- 3.9 -
SETTING THE INK DRYING TIME [DRYING TIME]
This function sets an ink drying time.
The drying time is the wait time by scanning and the time interval between the instant at which the
plotting operation is completed and the instant at which the medium plotted is cut off.
Specify the time to be established in accordance with the printing resolituion on a drawing and the
type of medium to be used.
• To enable the medium to be cut off automatically, it is necessary to specify
[AUTO CUT]. (See page 3.10)
STEP
1. Select a type.
(see page 3.4). Here, select [Type.1].
2. Push the [ENTER] key.
3. Set a drying time [Drying time] by pushing the
JOG keys [ ] and [ ].
4. Push the [ENTER] key.
5. Set a drying time after the scanning by push-
ing the JOG keys [ ] and [ ].
This is the drying time from the instant at which the carriage
returns to the capping station till the instant at which the
carriage starts moving again for plotting. The drying time that
can be set is 0.0 second to 9.9 seconds.
Here, select [1.0].
6. Push the [ENTER] key.
7. Set a drying time from the end of plotting to
the beginning of automatic cutting of the me-
dium by pushing the JOG keys[ ] and [ ].
The drying time that can be set is 0.0 second to 999 seconds.
Here, select [180].
8. Push the [ENTER] key.
9. Push the [END] key twice, and the menu returns
to the LOCAL mode.
SET UP
SELECT
: TYPE.1
TYPE.1
PRINT MODE
< ent >
TYPE.1
DRYING TIME
< ent >
TYPE.1
EACH LINE
: 0.0S
TYPE.1
EACH LINE
: 1.0S
TYPE.1
BEFORE Acut
: 0.0S
TYPE.1
BEFORE Acut
: 180S
TYPE.1
DRYING TIME
< ent >
<< LOCAL >>
width : 1272mm