MIMAKI JV4 Series, Руководство по эксплуатации

Страница: 75 / 152

- 2.7 -
INTERRUPTING THE PLOTTING OPERATION
To interrupt the plotting operation that has been started, stop the carriage and erase (the receive data)
from the device.
STEP
1. Push the [REMOTE] key to stop the plotting
operation.
2. If data is being transmitted from the computer
to the device, stop the data transmission.
3. Push the [DATA CLEAR] key.
The data that has been received is erased.
4. Push the [ENTER] key.
The device enters the LOCAL mode.
AFTER COMPLETING THE PLOTTING OPERATION
The operation to be performed by the operator at the end of the plotting operation (cutting off the
medium and switching off the power) is explained below.
• When Auto Cut has not been specified (See page 3.10), cut off the medium
using the following procedure.
•
If the head height is 3mm or more, cutting is not possible.
STEP
1. Put the device back into the LOCAL mode.
Push the [REMOTE] key and put the device back into the
LOCAL mode.
2. Push the [JOG] key until the LCD gives the
indication [ORIGIN SET UP].
Any of the JOG keys can be used.
3. Push the [FUNCTION] key.
4. Push the [ENTER] key.
Cut off the medium that has been plotted on.
5. The device enters the LOCAL mode.
The device returns to its initial condition.
6. Turn off the power to the device.
(See page 1.21)
<< LOCAL >>
width : 1272mm
DATA CLEAR
< ENT >
<< LOCAL >>
width : 1272mm
<< LOCAL >>
width : 1272mm
ORIGIN SET UP
0.0 - - - - - -
MEDIA CUT
< ENT >
MEDIA CUTTING
PLEASE WAIT
<< LOCAL >>
width : 1272mm