MIMAKI JV4 Series, Руководство по эксплуатации

Страница: 108 / 152

- 3.28 -
CORRECTING THE MEDIUM FEED RATE ACCORDING TO MEDIUM THICKNESS
[MEDIA COMP.]
The device plots an image on the medium while feeding it forward little by little.
When the thickness of the medium changes, the optimum feed rate changes accordingly. If this
occurs, the device may not plot a clear image (e.g., unwanted stripes may appear on the image). To
correct the medium feed rate according to the medium thickness, execute this function and make a
plotting test.
STEP
1. Select a type.
(See page 3.4). Here, select [Type.1].
2. Push the [ENTER] key.
3. Push the [ ] and [ ] key until the display gives
the indication [MEDIA COMP.].
4. Push the [ENTER ] key.
5. Push the [ENTER] key.
Test plotting for correction of the medium feed rate starts.
Seven types of medium correction patterns are plotted.
6. Enter a correction value from the output pat-
tern.
Enter the correction value by pushing the JOG keys [ ] and
[ ].
If the printed pattern has a gap between lines
: Decrease [ADJUST].
If lines of the printed pattern overlap: Increase [ADJUST].
• When [ADJUST] is changed to 15, the pattern
moves by about 0.1 mm. Determine the correc-
tion value referencing this amount of movement.
7. Push the [ENTER] key.
8. Push the [END] key three times, and the menu
returns to the LOCAL mode.
SET UP
SELECT
: TYPE.1
TYPE.1
PRINT MODE
< ent >
TYPE.1
MEDIA COMP.
< ent >
TYPE.1
PRINT START : ent
PRINTING
PLEASE WAIT
TYPE.1
ADJUST
= 0
TYPE.1
PRINT START : ent
<< LOCAL >>
width : 1272mm
Optimum pattern
Overlap
Gap between lines