MIMAKI JV4 Series, Руководство по эксплуатации

Страница: 105 / 152

- 3.25 -
TO PERFORM CLEANING AUTOMATICALLY DURING PATTERN PLOTTING
[AUTO CLEAN2]
Set the automatic cleaning during pattern plotting.
To prevent from occurring defect during pattern plotting, automatic cleaning is performed.
ON : Performs cleaning of the head automatically during pattern plotting.
OFF : Does not perform cleaning of the head during pattern plotting.
If setting to [ON], you can select a cleaning type and an interval to perform cleaning automatically.
Clean Type : SOFT, NORMAL and STRONG (refer to P2-9)
Performing interval : 0.1 m to 100.0 m (set by 0.1 m)
• If the ink is almost empty, this function will not be performed.
• A normal pattern may not be obtained because of the head status etc. even
after performing cleaning.
STEP
1. Select a type.
(See page 3.4). Here, select [Type.1].
2. Push the [ENTER] key.
3. Push the [ ] and [ ] key until the display gives
the indication [AUTO CLEAN2].
4. Push the [ENTER] key.
5. Push jog key [ ] or [ ] to select [OFF] or [ON].
Here, select [ON].
6. Push the [ENTER] key.
If selecting [OFF] in Procedure 5, go to Procedure 11.
7. Push jog key [ ] or [ ] to select a cleaning
type.
There are three cleaning type: [SOFT], [NORMAL] and
[STRONG].
Here, select [NORMAL].
SET UP
SELECT : TYPE.1
TYPE.1
PRINT MODE
< ent >
TYPE.1
AUTO CLEAN2
< ent >
TYPE.1
AUTO CLEAN2
:ON
TYPE.1
AUTO CLEAN2
:OFF
TYPE.1
CL TYPE
:SOFT
TYPE.1
CL TYPE
:NORMAL