MIMAKI DS-1600, Руководство по эксплуатации

Страница: 73 / 172

- 2.7 -
Printing an image from saurce data
Starting the plotter operation
This section describes the basic operation of the plotter.
Printing conditions can be set on the plotter side. In this section, however, the method of
printing an image from data that has been set on the computer side and transmitted to the
plotter is explained.
For the method of setting printing conditions on the plotter side, see Chapter 3 "How to Use
the Application Functions."
STEPS:
1. Turn the power on.
(See page 1.20)
2. Set the fabric in position.
(See page 1.35)
After detecting the media, the menu enters the LOCAL mode.
3. Press the [REMOTE] key.
4. The plotter receives the data from the computer.
The printing conditions that have been set for the data are
displayed.
For the method of data transmission, see the manual for the
output attached to the software.
5. Start the printing.
During the printing operation, the length of the fabric plotted on
is displayed.
• If the data transmission breaks up for 30 sec-
onds or more, the indication on the right will
appear.
6. After the printing operation is completed, press
the [REMOTE] key to put the mode back into the
LOCAL mode.
Displaying
alternately
< < L O C A L > >
w i d t h : 1 2 7 2m m
< R E M O T E >
T Y P E 1
0 . 0 m
< R E M O T E > V 3 6 0 x 3 6 0
A / S T / 4 P / U /
* * . * m
< R E M O T E > V 3 6 0 x 3 6 0
T Y P E 1
* * . * m
< R E M O T E >
D a t a W a i t i n g
< < L O C A L > >
w i d t h : 1 2 7 2m m