MIMAKI DS-1600, Руководство по эксплуатации

Страница: 38 / 172

- 1.20 -
Switching ON/OFF the power supply
After setting up the plotter, switch on and off the power as described below.
Turning the power on
STEPS:
1. Turn on the power to the computer, etc. that are
connected to the device.
2. Turn on the power to the plotter.
Tilt the power switch toward the “ I ”side, and the power to the
plotter is turned on.
• At this time, the front cover must be closed.
With the front cover kept open, the carriage
does not move even when the power is
switched on.
When the power is switched on, the LCD first displays [BOOT]
and then displays the firmware version number.
The message “PLEASE WAIT” appears flashing on the LCD.
The menu enters the LOCAL mode.
• If a fabric has been set on the plotter, the
prompt [MEDIA SELECT] is displayed on the
LCD when the power is switched on.
After selecting media , the plotter detects the
media and returns to the LOCAL mode.
B O O T
D S - 1 6 0 0 AM F V * . * *
P L E A S E W A I T
< < L O C A L > >
M E D I A S E L EC T
R O L L < > L E A F
< < L O C A L > >
w i d t h : * * * * m m