MIMAKI DS-1600, Руководство по эксплуатации

Страница: 34 / 172

- 1.16 -
3. Insert the lapel bar into the hole of the side plate
and then allow it to slip in the lower slot.
4. Make sure that the bearing is put into the side
plate and that the lapel bar is set to the position
where it rotates easily.
5. Holding the left and right thumb-screws, pull out
the slide plate toward the rear side of the plotter
and then turn the thumb-screws to secure them.
Attaching the platen boards
Attach the platen boards when using a fabric without ink penetration.
Set the attachment position and orientation of the platen boards in three steps according to
the degree of ink penetration. (See page 1.13)
(1)
(2)
The F cover
is closed.
The F cover
is open.
Loosen eight screws
and then close
the F cover L and R.
Loosen eight screws
and then open the
F cover L and R.