MIMAKI DM2-1810, Руководство по эксплуатации

Страница: 13 / 146

- ix -
Precautions in use
CAUTION
Periodic exchange parts
•
There are some parts which
must be replaced by service
engineer. You have to make a
contract with distributors or
dealers for after-sale service.
Protection against dust
• It is strongly recommended to
use the device in a room that
is not dusty. Set the Refresh
level 2 or 3 when in bad
environment.
( page 4.6)
• Keep the front cover to be
closed also when the machine
is not engaged in printing. If
not, dust can accumulate on
the head nozzle.
• When leaving the workshop
after the working hours, be
sure to take off any medium
from the roll hanger. If any
medium is left on the roll
hanger, dust can put on it.
•
Store medium in a bag. Wiping
off dust accumulated on a
medium will adversely affect
the medium due to static
electricity.
• Frequently clean the capping
station to eliminate dust and
paper chips.
•
Dust in the head will also
cause drops of ink to fall on
the media during plotting. If
this phenomenon takes place,
be sure to clean up the head.
( page 3.4)
Safety precautions during installation
Station cover
•
Never open the the station cover
during plotting. Opening the
station cover will abort plotting.
Keep the machine level
• Adjust the level feet to keep the
machine level at all times.
Warning labels
•
This machine is adhered with ten
warning labels. Be sure under-
stand firmly the warnings given
on the labels. In the case where
any of the warning label has
become so soiled that the
warning message is illegible or
has come off, purchase a new
one from your local distributor or
our office.
Refer to Appendix for the label
adhering locations.