MIMAKI CG-AR, Руководство по эксплуатации

Страница: 16 / 24

Plotter Driver Setup
16
Etc
1
Click [ Preferences ] on the [General] tab in [Printer properties] in
"Plotter Driver Setup" - Step 6 (P.12) .
2
Click the [ Etc ] tab.
• Configure the settings to suit your particular usage requirements.
(1) Command
Set to the same setting as for [COMMAND] on the plotter itself.
(2) Driver DPI
Sets the driver resolution.
(3) mm/inch
Selects the length units (mm or inches).
(4) Configuration parameter
Save settings........Saves the specified driver settings.
Load settings ........Loads a saved settings file and changes the driver settings.
(5) Version
Displays the plotter driver version information.
(6) Help
Displays help information.
(7) Initialize all
Initializes all of the settings.
• Select 720 × 720dpi if the cutting quality is coarse or when cutting small characters.
(1)
(3)
(2)
(4)
(5)
(6)
(7)