MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 67 / 110

– 3.17 –
Sample cut [SAMPLE CUT]
In the case where the device fails to cut data correctly or the end point of cutting of a character fails
to meet the starting point, the cause of such a fault can be checked up by cutting the characters
“Cut.”
•
In the case where the device is able to normally cut the characters “Cut” but
fails to cut other data:
The host computer is faulty.
•
In the case where the device fails to cut both the characters “Cut” and other
data:
The device may be faulty. Contact your distributor.
Execution of dump [DUMP]
This function is used to cause the host computer to send data to the device, then cause the device to
plot the communication conditions of the interface through which it receives the data, and finally
cause the device to plot the data received in ASCII format.
To execute the dump, be sure to use a pen as the tool.
The dump can be executed with the interface to which the host computer is connected.
• To put the dump on hold, press the key to change over the operation
mode to the local ode and execute the data clearing (see page 3.10).
• An example of the dump output is given in Appendix C for reference.
Execution of list output [LIST]
With this function, the device plots tool conditions, communication conditions and functions setting
conditions for your notes or for facsimile sending at the of maintenance.
Use a pen as a tool and plot on a leaf paper (A4 size paper in portrait orientation).
• An example of the list output is given in Appendix C for reference.