MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 43 / 110

– 2.21 –
Loading a roll sheet (CG-100EX, 130EX)
In the case where a roll of sheet is used, roll stays are required to be mounted on the device.
Refer to page 1.10 for how to mount the roll stays.
1) Attach the roll bar assembly to the roll
stays.
Place the roll bar assy. in the slit 1 or 2
according to the outside diameter of the roll
sheet to be used. Fit the turn-back lever
• If the outside diameter of the roll
sheet is 3 inches or more, put the
roll bar assy. in the slit 1 or 2.
• If the outside diameter of the roll
sheet is 3 inches or less, put the roll
bar assy. in the slit 2 or 3.
• In the case where two rolls sheet are
loaded on the device, the turn-back
lever works to prevent the lower
roll sheet from coming in contact
with the upper one.
2) Load a roll sheet.
Place a roll sheet on the roll bar, pass the top
end of the sheet through the platen and change
the location of the pinch rollers according to
the sheet width.
* Change the location of the pinch
rollers so that each one is placed 5
mm or more inside the sheet width.
If not, the sheet can slip off the
pinch rollers while it is being fed.
3) Lock the roller stoppers.
Press the lock lever toward the rear from the
front of the main unit to lock them.
• The roll stoppers work to prevent
the roll sheet from turning when
you draw out the rolled sheet.
12
3
4
Lock
Sheet