MIMAKI CFL-605RT, Руководство по эксплуатации

Страница: 164 / 170

6-20
Sample Cut
IIn case that normal data cutting cannot be performed etc., perform cutting with the sample stored in this plotter
to find out the cause of cutting error.
• If there is data that has not been cut in the receive buffer, an error is displayed and can not cut the
sample. Run the data clear at first.
Overview of the Self Test
PATTERN CUT 1
Uses the tool selected by the Tool Select function.
The sample is a Japanese family crest using a
variety of line segments.
PATTERN CUT 2
The sample is a paper pattern for the apparel
industry. The outer lines are cut after drawing the
inner lines.
SAMPLE 0.5 mm
Use this to make a paper container sample from
thick paper (approx. 0.5 mm thick). The perimeter is
cut after cutting the grid. Requires thick paper at
least A4 in size.
SAMPLE1.0 mm
Use this to make a paper container sample from
corrugated cardboard (approx. 1 to 2 mm thick). The
perimeter is cut after cutting the grid. Requires
corrugated cardboard at least A3 in size.
SAMPLE 1.5 mm
Use this to make a paper container sample
from corrugated cardboard (approx. 1.5 to 3
mm thick). The perimeter is cut after cutting
the grid. Requires corrugated cardboard at
least A2 in size.
SAMPLE BUFFER
Use this to make a cushioning material sample from
urethane form (sponge 10mm thick).
R = 3 / 5 / 10 / 20 / 50 / 100
Cuts a circle with the selected radius. (Radius (R) =
3, 5, 10, 20, 50, 100 mm)
Necessary tool
A unit: Swivel cutter
B unit: Roller1
Necessary tool
A unit: Swivel cutter
B unit: Roller1
Necessary tool
B unit: Roller1
Change the tool to
reciprocating in the
middle
Necessary tool
B unit: Roller1
Change the tool to
reciprocating in the middle
Necessary tool
B unit:
Reciprocating cutter1