MIMAKI CFL-605RT, Руководство по эксплуатации

Страница: 130 / 170

4-14
Confirm the following when failed in cutting correctly
Alignment of MARK SENSOR
The offset value of the cutter and the mark sensor can be adjusted.
Set the sheet on which the register mark is printed.
1
Install a cutter in the tool holder.
2
Confirm that the plotter is in the local mode.
3
Press the key.
4
Select [MARK SENSOR] by pressing the jog key
or .
5
Press the key.
6
Select [SENSOR OFS] by pressing the jog key or
.
7
Press the key.
• After detecting registration mark (1pt), cut the center line of the
register mark and both sides of five auxiliary lines every 0.2 mm.
<
LOCA L >
A : S W I V E L
<
LOCA L > 

S E T U P [ E N T ]
FUNCTION
< F U N C T I O N >


MA R K S E N S O R [ E N T ]
< MA R K S E N S O R >


S E N S O R O F S [ E N T ]
< MA R K S E N S O R >


S E N S O R O F S [ E N T ]
< S E N S O R O F F S E T >
X = 0 . 0 mm Y = 0 . 0 mm
X direction
Y direction
Misaligned by +0.2 mm
from the center line of the
register mark ( ) in
the X and the Y direction.