MIMAKI CF3-1610, Руководство по эксплуатации

Страница: 31 / 166

1-17
1
Setup
Blades and Workpieces
The types of workpiece that can be cut and the blade types that can be used differ according to the plotter model.
Workpiece Types that Can be Cut by Each Model (Guide)
Blade Types that Can Be Used in Each Model
Model TF2 Model R1 Model M
PVC sheet for signs Corrugated cardboard Channel
Reflective sheet PVC sheet for signs Aluminum composite panel
Joint sheet Coated board Timber
Sandblasted rubber Plastic corrugated sheet Plastic
Coated board Reflective sheet
Paternhaport Sandblasted rubber
Paternhaport
• Various types of workpiece may exist with the same name. Use the workpiece types in the table above
as a guideline only.
Always make a test cut before cutting actual workpieces. (P.2-22)
Tool (Cutter) Type
Model TF2 Model R1
Model M
A B C A B C
Cutter
High-speed, 30°
○ ○ ○ ○
Carbide, 30°
○ ○ ○ ○
Titanium-coated, 30°
○ ○ ○ ○
High-speed, 45°
○ ○ ○ ○
Carbide, 45°
○ ○ ○ ○
Titanium-coated, 45°
○ ○ ○ ○
High-speed, 7mm
○ ○ ○
Carbide design cutter, 30°
○ ○ ○
Titanium-coated double-edged cutter
○ ○ ○
Carbide double-edged round cutter
○ ○ ○
Carbide, 2°
○
20 mm cutter
○
Carbide, 17°
○
Pen
○ ○
Grid roller
○ ○
Swivel blade
○ ○
End mill
For aluminum composite panel
○
For 15 m channel
○
For 30m channel
○
For 50m channel
○
Timber
○
Plastic
○