MIMAKI CF3-1610, Руководство по эксплуатации

Страница: 155 / 166

6-21
6
Tr
ou
bleshoo
ting
Self Test
If the cutting quality is unsatisfactory, use the self-test function to determine if there is a problem with the
commands from the PC or with the plotter unit itself.
What is a Self Test ?
The plotter cuts, draws, and grid cuts 11 types of sample, without receiving commands from the PC.
If the cutting quality is poor, change the cutting conditions and adjust the tool. If these changes do not improve
the cutting quality, contact your Mimaki representative.
Overview of the Self Test
PATTERN CUT 1
Uses the tool selected by the Tool Select function.
The sample is a Japanese family crest using a variety
of line segments.
PATTERN CUT 2
The sample is a paper pattern for the apparel industry.
The outer lines are cut after drawing the inner lines.
DATA DUMP (P.6-24)
The unit draws the data sent from the PC as ASCII code to check for abnormalities.
SAMPLE 0.5 mm
Use this to make a paper container sample from thick
paper (approx. 0.5 mm thick). The perimeter is cut
after cutting the grid. Requires thick paper at least A4
in size.
SAMPLE1.0 mm
Use this to make a paper container sample from
corrugated cardboard (approx. 1 to 2 mm thick). The
perimeter is cut after cutting the grid. Requires
corrugated cardboard at least A3 in size.
SAMPLE 1.5 mm
Use this to make a paper container sample from corrugated
cardboard (approx. 1.5 to 3 mm thick). The perimeter is cut after
cutting the grid. Requires corrugated cardboard at least A2 in
size.
R = 3 / 5 / 10 / 20 / 50 / 100
Cuts a circle with the selected radius. (Radius (R) = 3, 5, 10, 20, 50, 100 mm)
PARAMETER DUMP
Conducts drawing with the conditions set in the unit.