MIMAKI CF2 Series, Руководство по эксплуатации

Страница: 76 / 186

— 2.28 —
SETTING CUTTING CONDITIONS [CONDITION]
Cutting conditions are set for the tool that has been selected in the [TOOL SELECT].
Setting items
Cutting condition setting items differ with the tools.
• In the case Approximate Type is set to “Arc” on the FineCut plotter settting,
excesive pressure may applied and damage the cutter depend on the media
type. When set to “Arc”, be sure to readjust the cut condition of FineCut or set
the [R speed] on the plotter. When [R speed] is set, [R speed] value is given
priority over the FineCut speed setting.
• When using a cutter holder 2N, be sure to set the “VIBRATION” of cut condi-
tion to “OFF”.
If “VIBRATION” is set to 1 to 5, cutter holder or this machine may be dam-
aged.
Tangential Crease Swivel
cutter roller blade
Speed The speed at which the tool moves. O O O O
Pressure A pressure that is applied by the tool to a work. O O O O
Accele The max. acceleration specified for the tool. O O O O
Change the acceleration in accordance with the types
of tools and works to be used as well as data sizes.
Offset Offset amount of the blade tip of the swivel blade is O
specified. Change the offset in accordance with the
work thickness and wear of the blade tip.
Front offset The amount of correction of the powition from which O O
cutting starts when the tool comes down.
For heavy-weight materials, the amount of correction
should be increased. This will cause the cutter to start
cutting from this side of the predetermined start
position, thereby allowing easy cut-out of the work.
Adjust the start position while checking the finished
state of products.
Setting item Description Pen
Work
Increase the
cutting depth Decrease the
cutting depth
Cutting start position in terms of data