MIMAKI CF2 Series, Руководство по эксплуатации

Страница: 134 / 186

— 4.14 —
ALIGNMENT OF MECHANICAL AXES TO
RULED LINES PRINTED [AXIS ALIGN]
If ruled lines such as scales are printed on a work, mechanical axes (X-axis, Y-axis) of the device
need to be aligned to them.
To set the mechanical axes, firstly establish an origin at the leftmost ruled line printed on the work
in terms of the X-axis direction. Secondly, enter the point (point A) of the rightmost ruled line to be
used to enter the inclination of ruled lines.
1
Cause the device to enter the LOCAL
state.
If the device is in the REMOTE state,
press the
R E M O T E
L O C A L
key.
2
Establish an origin at the leftmost one
of the ruled lines printed on the work.
See page 2.40.
3
Press the
PAGE
+ key several times un-
til the LCD indicates page 3 of the LO-
CAL MENU.
Origin
Point A
[ LOCAL ] 1 / 4
TOOL SELECT ———>
CONDITION ———>
TEST CUT ———>
R E M O T E
L O C A L
[ LOCAL ] 1 / 4
TOOL SELECT ———>
CONDITION ———>
TEST CUT ———>
PAGE
+