Milnor 48040H7R, Руководство по обслуживанию, Страница: 42 / 85

Chapter 3. Routine Maintenance
PELLERIN MILNOR CORPORATION
Figure 18: Grease ports for Door—Open Pocket Models. These are examples. Your machine can look
different.
Door Hinge—models with
manual door
Door Rod—models with
hydraulic door
Door Latch
Plunger—most
models
Door Open
Plunger—som
e models
Legend
.
1. Grease port, one place.
On some machines, the
door must be open for
access.
2. Grease ports, three places
3. No lubrication necessary
4. Apply a thin film of
grease to plunger surface.
Supplement 4
About the Shock Absorbers
Milnor washer-extractors with a rubber spring suspension also have shock absorbers. The shock
absorbers have a different type of connection than those for automobiles. It is not necessary to
replace the shock absorbers at specified intervals. It is only necessary to replace them if there is
an indication that they are damaged or very worn.
Examine the shock absorbers at the intervals given in the maintenance summary. It is necessary
to replace a shock absorber if you see oil come out from the mechanism (see the figure that
follows). This shows that seals are worn. It is also necessary to replace the shock absorber if the
rubber in a connector is very worn or missing.
Bad shock absorbers will let the shell move too much when the machine operates. If severe
movement occurs and you are not sure of the cause, you can do a test of the shock absorbers as
follows:
1. Remove the shock absorber from the machine.
2. With your body weight, compress the length of the shock absorber against a hard surface. A
serviceable shock absorber compress slowly. It will also expand slowly to its initial length
when you release it. If it compresses or expands quickly, the shock absorber is bad.
38