Milltronics VM Series, Инструкция по эксплуатации, Страница: 46 / 56

40
Weekly
•
Check operation of all cooling fans.
•
Check for proper air exhaust from the spindle air purge system (if equipped).
•
Clean any chips from on top of the ATC carousel and ATC slides.
Monthly
•
Grease the machine per instructions in the manual (unless equipped with
Autolube), detailed specifications can be found in the mechanical manual.
•
Inspect ballscrews and rails to ensure they are receiving proper lubrication (linear
guideway machines). Visually inspect all oil lines.
•
Inspect ballscrews and way surfaces (conventional way machines). Adjust gibs if
necessary. Visually inspect all oil lines.
•
Inspect all belts for excess wear, damage, and proper tension.
•
Check drawbar cylinder hydraulic fluids reservoir. Top off with recommended
hydraulic oil if necessary.
•
Check operation of low air pressure switch (if equipped). Remove compressed air
source from the machine and verify that a red alarm message box appears at the
front panel display.
WARNING:
Arc flash and shock hazard. Follow ALL requirements in NFPA 70E for safe
work practices and for Personal Protective Equipment before opening electrical
cabinet or performing adjustments or diagnostic measurements while energized.
Only qualified personnel should attempt to take current and voltage readings or
perform service. See the safety checklist on page 2 for qualifications.
•
Power down the machine. Open the door to the electrical cabinet at the back of
the machine. Check for loose wires or loose components.