C
HAPTER
1 - S
AFETY
Safety Related to Workpiece Machining And Tooling
1. DANGER
•
Never operate the spindle above the rated speed of accessories mounted on
it (chucks, tooling, etc).
•
Do not extend stock out of a lathe headstock without an appropriate bar feed
or support.
2. WARNING
•
Always use tools suitable for the work and that conform to machine
specifications.
•
Replace badly worn tools.
•
Be sure that all workpieces and fixtures are secured properly.
•
Do not overhang any work piece on a mill table.
•
Never operate the machine beyond its specified power limits.
•
Never machine flammable or explosive materials.
•
Never use flammable materials as cutting fluid.
3. CAUTION
•
Be sure the tool length is such that the tool will not interfere with any fixtures
or other objects.
•
Perform test operations after mounting tools.
Safety Related To Machine Maintenance
•
Maintenance should be performed only by qualified personnel as defined in
the safety checklist on page 2.
•
Beware that the machine cross slide can fall if unsupported while servicing
the X-axis motor or ballscrew. Brace the cross slide while servicing in this
area.
•
Maintain a clean floor around the work area.
•
Employ proper lighting in the area.
•
Ensure any ladders used are safe, stable, and secure.
•
Ensure all hardware is tight and properly tightened after performing
maintenance operations.
5
Содержание SL10 Series
