Using the Elix System
24
5.
When RINSING Mode is finished, the Elix System will go into PRODUCTION Mode.
If a Polisher Upgrade Kit or a Loop Resistivity
Sensor has been added, then this LCD may look
different. See Section 3-2.
6.
The Elix System will stay in PRODUCTION Mode until TANK FULL Mode. TANK FULL Mode results when a level sensor device
on a storage reservoir indicates that it is full. In this example, the reservoir water level went from 40% full to 100% full. The
Product Water Resistivity shown in TANK FULL Mode is the last value measured in PRODUCTION Mode.
7.
Press STANDBY to exit PRODUCTION Mode if you do not want to go to TANK FULL Mode.
A
LARM
M
ESSAGE
D
ISPLAYED
1.
Certain Alarm Messages, when activated, will cause PRODUCTION Mode to stop (i.e. LOW FEED PRESSURE Mode). See
Section 5-1 for an explanation of the Alarm and Maintenance Messages.
2.
When the cause of the Alarm Stop Message has been corrected, press RESUME to go back to PRODUCTION Mode.
R I N S I N G
▄
4 0 %
P R O D U C T : 1 3 . 1 M
Ω
T C
T O C : 2 1 p p b
D A T A
S T A N D B Y
P R O D U C T I O N
▄
4 0 %
P R O D U C T : 1 3 . 1 M
Ω
T C
T O C : 2 1 p p b
D A T A
S T A N D B Y
P R O D U C T I O N
▄
4 0 %
P R O D U C T : 1 3 . 1 M
Ω
T C
T O C : 2 1 p p b
D A T A
S T A N D B Y
T A N K F U L L
9 9 %
P R O D U C T : 1 3 . 1 M
Ω
T C
T O C : 2 1 p p b
D A T A
S T A N D B Y
P R O D U C T I O N
▄
4 0 %
P R O D U C T : 1 3 . 1 M
Ω
T C
T O C : 2 1 p p b
D A T A
S T A N D B Y
S Y S T E M S T O P P E D
▄
4 0 %
- L O W F E E D P R E S S U R E
R E S U M E
S T A N D B Y
