Miller XT40 Torch, Руководство пользователя

Страница: 16 / 52

.
A complete Parts List is available at www.MillerWelds.com
OM-264 267 Page 12
General
Toppling or tilting Up to 15
°
incline − − − −
Machine Weight 21 lb (9.5 kg) including 12 ft (3.7 m) torch
23 lb (10.4 kg) including 20 ft (6.1 m) torch
− − − −
Torch −
The XT40 torch is intended for handheld use only. The torch conforms to IEC 60974-7 when used with the Spectrum 625
X-TREME. Do not use this torch in combination with any other machines.
Gas Type Air or Nitrogen
−− −−
Gas Quality
Clean, moisture − free,
oil − free
−− −−
Gas Inlet Flow and Pressure 6.0 SCFM (170 L/min)
90 PSI (621 kPa)
Min
120 PSI (827
kPa) Max
Gas Filtering Particulates to 5 microns
−− −−
Mild Steel capacities (see Section 6-2 for cutting speeds vs material type and thickness)
Cooling Method Air −− −−
Duty Cycle of Torch 100% at 40 Amps −− −−
Rating of Electrical Controls (Trigger) 30 VDC at .1 Amps − − − −
Rating of Electrical Controls (Cup) 30 VDC at 1 Amp − − − −
Approved Systems Spectrum 625 X-TREME w/XT40 torch
Trigger Protection Safety trigger guard
Safety Devices Safety interlock devices shut down power source
Rated Capacity (edge start) 5/8 in. at 13 ipm (330 mm/min)*
−− −−
Sever Cut Capacity (edge start) 7/8 in. at 4 ipm (102 mm/min)*
−− −−
Pierce Capacity 5/16 in.
−− −−
Gouge Mode Capacity**
240V Input 15A Min 40A Max
120V (20A) Input 15A Min 27A Max
120V (15A) Input 15A Min 25A Max
*Travel speeds are approximately 80% of maximum.
** Working air pressure must be at or above 90 PSI (621kPa).
Requirements for the torch connection
S Use only compressed air which is free from dirt, oil, and water.
S Ensure that the connections are properly assigned and tightened.
S For torch replacement, see Miller torch manual Part No. OM-254449
S Ensure correct air pressure (flow pressure) and airflow (volume) are set. Insufficient airflow can lead to the torch overheating.
4-3. Torch Dimensions And Weight
Ref. 253 554-A
2.2 lb (1.0 kg)
1-3/16 in.
(30 mm)
8-3/4 in.
(222 mm)
1-1/2 in.
(38 mm)