Miller TRAILBLAZER 275 DC, Руководство пользователя

Страница: 27 / 68

A complete Parts List is available at www.MillerWelds.com
OM-4426 Page 23
5-5. Engine Prestart Checks (Kohler-Powered Units)
Ref. 803 571 − A / Ref. 803 573 − A
Check all fluids daily. Engine must be
cold and on a level surface. Unit is
shipped with 10W30 engine oil.
Follow run-in procedure in en-
gine manual.
This unit has a low oil pressure
shutdown switch. However,
some conditions may cause en-
gine damage before the engine
shuts down. Check oil level often
and do not use the oil pressure
shutdown system to monitor oil
level.
Open top service door
Fuel
Add fresh fuel before starting engine
the first time (see maintenance label
for specifications). Stop fueling when
fuel level reaches neck tube. Do not
top off tank. Always leave filler neck
empty to allow room for expansion.
Check fuel level on a cold engine be-
fore use each day.
To check fuel level, turn Engine Con-
trol switch to Run/Idle position.
LED’s indicate fuel level in tank.
Oil
Do not exceed the ”Full” mark on
the oil level dipstick. The fuel
pump may operate erratically if
crankcase is overfilled.
After fueling, check oil with unit on
level surface. If oil is not up to full
mark on dipstick, add oil (see mainte-
nance label).
Use front panel meters to determine
hours until next recommended oil
change (see Section 6-1).
To improve cold weather
starting:
Keep battery in good condition.
Store battery in warm area.
Use correct grade oil for cold
weather.
Close top service door
Full
Oil Check/Fill
Oil Fill
Full
Empty
Full
Gasoline