OM-260311 Page 19
5-3. Preparing Unit For TIG Welding
1
Positive Weld Output Terminal
2
Remote Control Receptacle
3
Negative Weld Output Terminal
4
Amperage/Set-Up Adjustment
Control
5
Ammeter And Parameter Display
(Meter)
6
Process/Set-Up Selector Switch
7
TIG Welding Light (LED)
8
Ready Light (LED)
9
Set-Up Light (LED)
Prepare unit for TIG welding as follows:
Connect electrode holder to negative
weld output receptacle.
Connect work clamp to positive weld out-
put terminal.
If desired, connect a remote control to the
remote control receptacle.
Turn power on. Allow time for unit to com-
plete its start up cycle.
Press and release Amperage/Set-Up
Adjustment control to select TIG welding
and light corresponding LED. Display
meter displays TIG for three seconds
and then the factory default setting of 50
amperes.
.
The amperage range while TIG
welding is from 4 to 160 amps.
1
=Light Off
=Light On
=Light Flashing
Process Selection
Set-Up Menu
=Light Flashing If Voltage Reduction Device Is On
*
2
3
4
5
Press And Release
6
7
8
Press And Hold
*
9
