Miller OM-246 466B, Руководство пользователя

Страница: 35 / 76

OM-246 466 Page 31
4-7. PipePro 300 Set Up For Lift TIG (GTAW) Equipment
See Table 4-1 for selection choices.
1. Turn welding power source Power switch on (approximately 30 seconds for complete operation). Push Program
button. Use the Adjust knob to choose a desired program number from the 1 through 8 selection.
.
If the desired program has been previously loaded, only the program number needs to be selected. This process does not have to be followed
every time a different program is selected.
2. Push Setup button once. Use the Adjust knob to choose TIG weld Process.
3. Push Setup button again. Use the Adjust knob to choose type of Control (CTRL PANL or CTRL REMT).
a. If Panel control is selected, press the Wire Feed Speed/Amps display button for amperage output. Use the
Adjust knob to set the desired amperage.
b. If Remote control is selected, connect a remote device using a remote cable adapter (300 248) to connect
to an Interconnect Cable and then connect this cable to the PipePro 300. The remote device and the
welding power source are now in a master/slave control configuration. The Adjust knob on the welding
power source is used to control the maximum amperage that can be set by the remote device.
.
Lift TIG cannot have the Volt Sense lead connected to the PipePro 300 when connected for Electrode Negative (straight polarity).
4. Push Setup button again. The display will read PROG LOAD and welding power source is now ready for the
welding operation.
.
No changes are saved until PROG LOAD appears on the display after completing the settings. If the Setup button is pressed to review the settings
and nothing is changed, PROG LOAD will not appear on the display for the program that was just loaded.
200 410