Miller ENPAK, Руководство пользователя

Страница: 51 / 96

OM-261050 Page 47
10-7. Service Panel
260 718
1 Manual/Remote Switch
!
When working on unit, always
move Manual/Remote switch to
Manual position to prevent remote
or automatic starting.
This unit can be started from a remote loca-
tion or start automatically when this switch
is in the Remote position. Place switch in
Manual position when service side panel is
open or when Remote Panel is disconnec-
ted.
When this switch is in the Remote position,
the remaining switches on the service pan-
el do not function.
2
Engine Speed Switch
High position is 3600 RPM and is used
when generator power is required or the
compressor or hydraulic system will be
loaded.
Low position is 2600 RPM and is used
when light loads are present.
3
Fuel Pump Switch
Use switch to power the engine ECU mod-
ule and turn fuel pump on.
4
Engine Crank / Glow Plug Switch
See Section 6-5 for appropriate glow plug
timing. Push down to activate glow plugs.
To crank engine, push up. Once engine
has started, allow switch to return to center
position.
5
Compressor Switch
Use switch to turn compressor (clutch and
valve) on during manual operation.
6
Compressor Temperature LED
Indicates the compressor oil temperature
is too high
7 Compressor Pressure LED
Indicates the compressor pressure is too
high.
8
Engine Error LED
Indicates an engine error. See Table 10-1
for blink pattern.
9
Glow Plug LED
Indicates the glow plug is on.
10 Compressor On LED
Indicates the compressor is on.
11 Engine Crank LED
Indicates the engine is cranking.
12 Engine On LED
Indicates the engine ECU has power and
the fuel pump is active.
1 2 3 4 5
6
7
8
9
10 11 12