Miller ENPAK, Руководство пользователя

Страница: 57 / 96

OM-261050 Page 53
11-4. Changing Engine Oil, Oil Filter, And Fuel Filters
265 802-A / S-0842
!
Stop engine and let cool.
1 Oil Drain Valve
Oil drain valve can exit either side of
base.
2
Oil Filter
Change engine oil and filter accord-
ing to engine manual.
!
Close valve and valve cap
before adding oil and run-
ning engine.
Fill crankcase with new oil to full
mark on dipstick (see Section 6-4).
3
Fuel Pump With Filter
To clean fuel pump filter, the assem-
bly must be removed from the unit
base. Remove the screws on either
side of the fuel pump and maneuver
assembly out of the base without
disturbing the fuel line connections.
Unscrew the bottom portion of fuel
pump from the top to expose the fil-
ter. Clean filter and replace.
4
Primary Fuel Filter
Inspect fuel lines and replace line if
cracked or worn. Wipe up any
spilled fuel.
Start engine, and check for fuel
leaks.
!
Stop engine, tighten connec-
tions as necessary, and wipe
up fuel.
To reset engine maintenance
hours: Use the Display Select push
button on Remote Panel and scroll
to the Engine Maintenance Hours.
When the display shows engine
maintenance hours, press and hold
the Display Select button. This will
go through two displays that ask
RESET ??, and then RESETHr? If
the operator continues to hold the
button, dONE appears on the dis-
play and the engine maintenance
hours are reset to 400.
2
Tools Needed:
1
3
4
1