Mayfair
Fence Letterbox
231 / 232
1 x Front Panel
1 x Back Box
1 x Accessories Bag
Your carton should contain the
following parts:
Contents
Tools
- Drill
- Timber Drill Bits
- Tape Measure
Required
- Jigsaw
www.milkcan.com.au
(03) 9464 6964
56 Northgate Drive,
Thomastown VIC 3043
Choosing a Suitable Location
The letterbox can be mounted into a timber fence up to
20mm thick.
You will need to install it in a location that is
easily accessible to Australia Post and couriers.
The recommended height for the mail slot is 90 to 120cm
from the ground.
1. Remove the front panel by undoing the two mounting nuts
from inside the back box.
Installation
2. Using the enclosed template provided, mark and cut out
the mail opening using a jigsaw. Drill two 8mm holes for
the front panel studs.
1.1
Mounting
Stud
Back
Box
Front
Panel
3. Fit the front panel so its mounting studs pass through the
holes just drilled.
Attach the back box to the mounting studs through the
upper mounting holes.
4. Secure the front panel from inside the letterbox with the
washers and nuts provided.
Screw the back box to the fence through the lower
mounting holes with the screws provided (for hardwood
fences, it is easier to pre-drill the screw holes).
Upper
Mounting
Holes
Lower
Mounting
Holes
