4K 8x8 HDMI Matrix Switcher-N
13
Controlled by PC(s) in LAN
The MP-HD-88A-N can be connected with a router to make up a LAN with the PC(s),
this make it able to be controlled in a LAN. When control, just make sure the
MP-HD-88A-N
’s network segment is the same with the router. Please connect as the
following figure for LAN control.
Figure 4- 4 Connect to LAN
Step1.
Connect the TCP/IP port of the MP-HD-88A-N to Ethernet port of PC with
twisted pair.
Step2.
Set the PC
’s network segment to the same as the MP-HD-88A-N. Do please
remember the PC
’s original network segment.
Step3.
Set the MP-HD-88A-N
’s network segment to the same as the router.
Step4.
Set the PC
’s network segment to the original one.
Step5.
Connect the MP-HD-88A-N and PC(s) to the router. In the same LAN, each PC
is able to control the MP-HD-88A-N asynchronously.
Then it
’s able to control the device via a TCP/IP communication software.
4.3.2 Control MP-HD-88A-N via TCP/IP communication software
(Exampled by TCPUDP software)
1)
Connect a computer with TCPUDP software to MP-HD-88A-N. Open the TCPUDP
software (or any other TCP/IP communication software) and create a connection,
enter the IP address and port of MP-HD-88A-N (default IP: 192.168.0.178,
port:8080):
