See www.routerboard.com for more information. Contact [email protected] for support questions.
16-Oct-2012
RouterBOARD SXT 2nD r2
Quick Setup Guide and Warranty Information
The RouterBOARD SXT 2nD r2 comes as a complete set, and includes a
built in 802.11b/g/n dual chain wireless device, and a dual
polarization 16dBi antenna. It has one BASE-‐T 10/100 ethernet
connector which supports MDI-‐X auto detection.
First use
1.
Connect an Ethernet cable to the port behind the small plastic door
2.
The SXT accepts 24V Passive PoE from a PoE injector
3.
The default IP address from LAN is 192.168.88.1 for configuration
4.
Username is
admin
and there is no password
Powering
The board accepts powering from the Ethernet port (Passive PoE) 8-‐30V DC. Package contains a 24V adapter.
Maximum power consumption of the device is 7W.
Booting process
Initial connection has to be done via the Ethernet cable. Open
192.168.88.1
in your web browser.
Username is
admin
and there is no password. In case IP connection is not available, Winbox can be used to connect to the MAC address of the
device. More information here:
http://wiki.mikrotik.com/wiki/First_time_startup
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the de-‐
vice when starting it until the LED light turns off, and Metal will start to look for Netinstall servers.
Mounting
With the clip pointed forward, slide the mounting bracket into the rail on the bottom of the case, until the clip
clicks into place. The SXT comes bundled with a hose clamp -‐ guide the clamp through the opening in the bracket
and around the pole where it will be mounted. Tighten the hose clamp screw when alignment is complete. Two
screw holes are provided as additional security against accidental bracket movement.
The SXT device has a sliding door, behind which the Ethernet port, and the reset jumpers are located. This door
can be also secured shut with a screw in the provided screw hole.
