See www.routerboard.com for more information. Contact [email protected] for support questions.
19-Aug-2011
RouterBOARD OmniTik U-‐5HnD
Quick Setup Guide and Warranty Information
The RouterBOARD
OmniTik
comes preinstalled in an outdoor case, with a built-‐in 5GHz
802.11a/n wireless and five 10/100 Ethernet ports which support MDI-‐X auto detection.
There are two built-‐in antennas. One antenna is v-‐pol, the other is h-‐pol. Antenna gain is
7.5dbi. The device is packaged with a 24V power adapter, a PoE injector, a mounting
bracket and a hose clamp.
First use
1.
Open the small door on the bottom of the case and connect an Ethernet cable to
the Ethernet port. If you want to connect more than one Ethernet cable, you have
to break out the hole blockers.
2.
OmniTik accepts 8-‐30V Passive PoE on WAN port (ether1) from a PoE injector; the
package includes a 24V power adapter and a PoE injector.
3.
The default IP address from LAN (From ether 2-‐5 and wireless SSID “MikroTik”) is
192.168.88.1 for configuration
4.
Username is
admin
and there is
no password
Powering
The board accepts powering from the Ethernet port (Passive PoE):
•
Ethernet port accepts passive Power over Ethernet 8-‐30V DC. Package contains a
24V adapter and a PoE injector.
Maximum power consumption of the device is 9W.
Booting process
RouterOS is the operating system of all RouterBOARD routers. Please see detailed con-‐
figuration guide here
http://wiki.mikrotik.com/wiki/Category:Manual
This device doesn't come fitted with a Serial Port connector, so initial connection has to be done via the Ethernet cable, using
the MikroTik Winbox utility. Winbox should be used to connect to the default IP address of
192.168.88.1
with the username
admin
and
no password
.
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the de-‐
vice when starting it until the LED light turns off, and Groove will start to look for Netinstall servers.
In case IP connection is not available, Winbox can also be used to connect to the MAC address of the device. More infor-‐
mation here:
http://wiki.mikrotik.com/wiki/First_time_startup
Mounting
OmniTik comes bundled with one mounting bracket and one hose clamp for putting the device on a pole. You should avoid
connecting a loose Ethernet cable to the Ethernet port, secure the cable to a wall or the pole, so that the cable weight is not
pulling the port. It is recommended to secure the Ethernet cable less than 2m from the device. This is to ensure that the ca-‐
ble doesn't damage the port by its weight, or doesn't fall out.
