1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS
™
socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at
the mikroBUS
™
socket. If all of the pins are
aligned correctly, push the board all
the way into the socket.
3. Plugging the board in
2
3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards.
Place shorter pins of the header into the
appropriate soldering pads.
Before using your click
™
board, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
Joystick click Manual
ver. 1.00
0 100000 025062
Joystick click
™
is an accessory board in
mikroBUS
™
form factor. It’s a compact and
easy solution for adding joystick to your
design. It features
AS5013
Hall IC as well
as
N50P105
miniature magnetic joystick
module. Joystick click
™
communicates
with the target board microcontroller via
mikroBUS
™
I
2
C (SDA, SCL), INT, RST and CS
lines. The board is designed to use 3.3V
power supply only. LED diode (GREEN)
indicates the presence of power supply.
Joystick
click
Joystick click
™
with its
AS5013
IC and
N50P105
represents smart navigation
key concept based on contactless, magnetic
movement detection. The
AS5013
includes
five integrated Hall sensing elements which
are monitoring the movement of the magnet,
incorporated into the joystick, and provides
directly the x and y coordinates via I
2
C output.
An integrated mechanical push button is also
built in joystick.
