10
Installing the Mounts
When you at a circumstances where it is rain, underwater, liquids
splashing, near or among sanding and/or dirt/dust, etc., you should
put the Video Camera into waterproof case to protect it.
When you at a circumstances where it is out of risks mentioned
foregoing, you may directly install the Video Camera on the mounts
or use waterproof case with replaceable Heat Dissipation Cover to
improve recording quality of sounds.
Open/Close Waterproof Case Backdoor
For security purpose, the waterproof case
built with 2 latches (# 1 & #2 as below
illustration). To open the backdoor, you
should slide latch #1 down and then push
latch #2 backward; to close it, you should
lock the backdoor properly by latches then
push latches forward until both latch lock
well, you can hear a “Click” sound.
CAUTION:
1) Before close the backdoor, carefully check and make sure
there is nothing extra sticking on rubber seal of backdoor and
camera housing. A single hair or a grain of sand will cause
water leakage and damage your camera.
2) Before use, make sure backdoor closes and locks well.
3) To prevent corrosion on waterproof case and its rubber seal,
after each use in salt water, put waterproof case into clean
container with clean tap water for half an hour and then rinse
the waterproof case for a while to remove salt thoroughly. Then
air dry it or dry it by a cloth.
