Risk of damage to the device from condensation!
– Only use the device in a dry environment.
– Never store the device in damp places.
– Let the device acclimatize in the event of location changes.
– In the event of faults, immediately disconnect the device
from the power supply and notify Customer Service
“Customer service” on page 16).
– Never switch on the device if condensation is visible.
Condensation can form in the event of changes in humidity
and temperature. Moisture in the control unit can result in
damage or even total destruction.
Risk of damage to the device from not observing the oper-
ating temperatures!
– Before the workout, ensure that the device is at the pre-
scribed operating temperature
– Observe the time needed to cool down or warm up the
device
Chapter 3 “Technical data” on page 36.
9.2 Connecting the device
Personnel:
n
Trainer
The control unit can be operated with or without a power supply
unit. The connection between the control unit and the person
training is always wireless. For more information, see the “i-body®
connect wireless” manual.
1.
Remove the connector cover of the electrical connection on
the control unit (Fig. 53/1). Connect the magnetic plug of the
power supply unit (Fig. 53/2) into the magnetic socket of the
control unit.
2.
When connecting the power cable (Fig. 53/2), make sure
the magnetic plug connection is safely locked in place.
Connect the power cable to the power supply unit (Fig. 53/2).
ð
Attach the control unit to either the “travel station m.ove”
or the “work station m.ove” accessory. For more informa-
tion, see the assembly instructions for the “travel station
m.ove” or the “work station m.ove”.
Condensation
NOTICE
Observing the operating tempera-
tures
NOTICE
Connecting the control unit
2
1
Fig. 53: Connecting the control unit
Training with the device
2021-07-28
miha-bodytec m.ove EMS training device
84