8
Instructions for Installing the Optional RB709U-NB Receiver
Step 1:
The RB709U-NB will replace the gate opener receiver; disconnect
the gate opener receiver’s RED, BLACK and GREEN wires from the receiver
terminals on the gate opener control board.
Step 2:
Mount the RB709U-NB Receiver.
• The Receiver can be mounted up to 10 ft. from the gate opener control
board.
• DO NOT mount the Receiver upside down.
• DO NOT mount on a metal surface (will reduce range).
• Run Receiver cable through PVC conduit to protect it from damage.
• DO NOT run Receiver cable in conduit containing AC wiring.
• Receiver range can vary depending upon weather, topography and external
interference.
Step 3:
Connect the RED and BLACK wires from the Receiver to the power
supply (see illustration, page 5).
CAUTION: The “Learn” process may activate the gate. Please use caution when programming the Receiver.
Note:
You will have to use a small screwdriver or a pen to depress
the LEARN CH buttons on the receiver.
Step 4:
Connect the Receiver’s Channel 1 wires (GREEN and
BLUE) to your control board (see illustration, page 5). Press and
hold the Entry Transmitter button then the Receiver’s LEARN CH
1 button at the same time. The indicator light on the Receiver
should blink once within 1–2 seconds to indicate that the Entry
Transmitter setting is now programmed into the Receiver.
RCVR
GRN
BLK
RED
RCVR
R B G
RECEIVER
BLK
GRN
RED
Receiver Terminal Blocks
CAUTION: The “Learn” process may activate the gate. Please use
caution when programming the Receiver.
*RB709U-NB Receiver is only required for installations on MM360 systems and
select legacy systems. Please call technical support for details.
Indicator Light
Learn Channel Buttons