10
5. Test the System
Step 1:
Make sure gate opener is turned ON and gate is in the closed position.
Step 2:
Remove and install 2 “AA” batteries (included) in the Transmitter Module;
the gate will open
. Wait 60 seconds
before proceeding to the next step and
DO NOT move the sensor, any vehicles, or metal objects that are within 25 ft. during this
calibration/”self-test” 60-second period
.
Step 3:
Use your Entry Transmitter to close the gate. Test the Wireless Vehicle Sensor by driving your vehicle past the
Sensor at normal driveway speed. The gate should open each time; if it does not, use a small screwdriver to increase the
Sensitivity Adjustment (clockwise rotation).
Step 4:
Once operation is satisfactory, turn the gate opener OFF. Fill the holes and trench with soil and tamp firm. The
bottom third of the Mounting Post should be buried firmly in the ground.
Step 5:
Turn the gate opener ON and make sure gate is in the closed position. Replace Transmitter Module cover and
test the system again (Step 3).
NOTE:
Do not cover the Transmitter Module with anything metal, as this will cause signal interference.
Your installation is now complete. If your Wireless Vehicle Sensor is not working properly, please refer to the
Troubleshooting Guide
on back cover.
GTO WIRELESS EXIT WAND
TRANSMITTER
MIN
MAX
SENSITIVITY
