Problem solving guide
65
Fault messages at the end of a programme
Problem
Possible cause and remedy
Check detergent
Excessive foam has built up during washing.
With TwinDos, check the dosage amount set.
Reduce the amount set in 10% increments.
Use less detergent next time and follow the
manufacturer's instructions on dosage given on
the packaging.
Hygiene info: Run a
programme at min.
75°C or "Clean
machine'"
programme
When washing, a wash programme using a
temperature above 60°C has not been run for a long
time.
Turn the programme selector to
Further
programmes
/
.
Touch the
sensors until
Maintenance
appears
in the display.
Touch the
OK
sensor.
The following appears in the display:
Clean machine
Touch the
OK
sensor.
Run the
Clean machine
programme using the Miele
IntenseClean machine cleaner or a universal
powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
Align the washing
machine
The
Pre-ironing
Extra at the end of the programme
could not be carried out properly.
Check whether the washing machine is aligned
correctly (see "Installation – Levelling the
machine").
Check whether the maximum drain height of 1 m
has been exceeded.
If the fault message appears again, contact Miele. The
washing machine can still be used, but without the
Pre-ironing
Extra.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the
OK
sensor.
Содержание WWG 660
Страница 100: ......
Страница 101: ......
Страница 102: ......
Страница 104: ...M Nr 11 409 950 00 en AU NZ WWG 660 ...