Problem solving guide
64
Fault messages after a programme has been cancelled
Problem
Possible cause and remedy
Check drainage. See
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the filters and the drain pump.
The maximum drain height is 1 m.
Water intake. See
The water inlet is blocked or restricted.
Check whether the tap is turned on properly.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
Clean the filter.
The drain pump is activated for 2 minutes. The washing
machine door is then released. Wait for the drain pump
to stop before switching the machine off.
Service
Waterproof syst.
Turn off
The water protection system has reacted.
Turn off the tap.
Call Miele.
Service Fault F
There is a fault.
Disconnect the washing machine from the
electricity supply. Switch off at the wall and
withdraw the plug from the socket, or switch off
the mains circuit breaker.
Wait
at least 2 minutes
before reconnecting the
washing machine to the electricity supply.
Then switch the washing machine on again.
Restart the programme.
If the fault message appears again, contact Miele.
To switch off the fault message: Turn the programme selector to the
position to
switch the washing machine off.
Содержание WWG 660
Страница 100: ......
Страница 101: ......
Страница 102: ......
Страница 104: ...M Nr 11 409 950 00 en AU NZ WWG 660 ...