Problem solving guide
87
Fault messages at the end of a programme
Message
Possible cause and remedy
Intensive flow: Clean
the filter and jet
nozzle or remove
foreign objects from
the pump housing
The pumps are dirty.
Clean the pumps as described in the “Problem
solving guide – Opening the door in the event of a
blocked drain outlet and/or power cut”.
Restart the wash programme after cleaning.
The jet in the top of the door ring is blocked with fluff.
Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
Restart the wash programme after cleaning.
If the fault message appears again, contact Miele.
The washer-dryer can still be used but with reduced
functionality.
Check load
There is no laundry in the drum.
The load is too small. The laundry is still damp
because the residual moisture content in the laundry
cannot be measured.
In the future use a
Timed drying
programme for
small amounts of laundry.
The amount of laundry exceeded the maximum load
for the selected programme.
Observe the maximum loads listed in the
Programme chart.
Start "Rinse out fluff"
programme in the
"Maintenance"
menu
The
Rinse out fluff
programme has not been used for
a long time.
Start the
Rinse out fluff
programme as described
in “Cleaning and care – Starting maintenance
programmes”.
To switch off the fault message, switch the washer-dryer off with the
sensor.
Содержание WTW 870 WPM
Страница 126: ......
Страница 128: ...M Nr 11 976 031 01 en AU NZ WTW 870 WPM ...