![Miele WTR 860 WPM Скачать руководство пользователя страница 122](http://html.mh-extra.com/html/miele/wtr-860-wpm/wtr-860-wpm_operating-instructions-manual_237777122.webp)
Settings
122
Appliance parameters
Copyrights and Licences
Miele uses their own and third party
software which is not subject to any so-
called Open Source Licence for the op-
eration and control of the appliance.
This software/these software compon-
ents are protected by copyright. The
copyright powers of Miele and third
parties have to be respected.
Furthermore, this appliance contains
software components which are distrib-
uted under Open Source licence condi-
tions. Please refer to the menu item
Set-
tings
|
Appliance parameters
|
Legal informa-
tion
|
Open source licences
in the appli-
ance for the Open Source components
contained therein, together with the
corresponding copyright notices, cop-
ies of the licencing conditions valid at
the time, and any further information.
The liability and warranty provisions of
the Open Source licence terms and
conditions as stated therein apply only
in relation to the respective rights hold-
ers.
Installation requirements
Low water pressure
If the water pressure is too low, the
washer-dryer will stop the programme
and a water inlet fault message will
appear.
This setting can be activated to ensure
problem-free water intake where the
water pressure is constantly low.
Factory default setting:
Low water pres-
sure
is switched on.
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a Cot-
tons programme with a temperature of
70 °C or higher is selected.
Activate suds cooling:
- To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or slops basin
- In buildings where the drainage pipes
do not comply with DIN 1986
Factory default setting: suds cooling is
switched off.
Содержание WTR 860 WPM
Страница 128: ...M Nr 11 584 430 02 en GB WTR 860 WPM ...