Miele SmartLine CS 7612 FL, Инструкции по эксплуатации и монтажу

Страница: 47 / 80

Problem solving guide
47
With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be remedied
without contacting Miele. This will save you time and money because you won't
need a service call.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
Messages in the display
Problem Possible cause and remedy
After the SmartLine
appliance has been
switched on or a sensor
control has been
touched,
 appears in
the timer display for a
few seconds.
The system lock or safety lock is activated.
 Deactivate the system lock or safety lock (see
“Safety features - System lock / Safety lock”).
After the SmartLine
appliance has been
switched on,
 appears
briefly in the timer
display. The SmartLine
appliance does not heat
up.
The SmartLine appliance is in demonstration mode.
 Touch the 0 and 2 sensor controls at the same
time until
 flashes alternately with  in the
timer display.
The SmartLine
appliance has switched
off automatically. When
the appliance is
switched back on,

appears above the On/
Off
 sensor control.
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over, or an object.
 Clean off any dirt and/or remove the object (see
“Safety features – Safety switch-off”).
 flashes alternately
with

in the timer
display and a tone is
sounding.
The SmartLine appliance is connected incorrectly.

Disconnect the SmartLine appliance from the
mains.

Contact Miele.

will flash alternately
with

in the timer
display.
The overheating protection mechanism has been
activated.
 See “Safety features - Overheating protection”.