Miele PWM 906, Инструкции по эксплуатации и монтажу

Страница: 74 / 100

Installation and connection
*
I
N
S
T
A
L
L
A
T
I
O
N
*
74
Water connection
Cold water connection
The washing machine should be
connected to a regular water supply in
accordance with current local and
national safety regulations. The
machine is equipped with a safety
system for the protection of drinking
water and may be connected to the
water supply without a non-return valve,
if national regulations permit.
The flow pressure must amount to a
minimum of 100 kPa (14.5 psi) and
must not exceed 1,000 kPa (145 psi). If
the pressure exceeds 1,000 kPa, a
pressure reducing valve must be
installed.
For the connection, a shutoff valve with
a ¾-inch male garden hose thread is
required. If this type of shutoff valve is
not available, only a qualified installer
may connect the washing machine to
the domestic water supply.
The connection point is subject to
domestic water pressure.
You should therefore open the
shutoff valve slowly and check for
leaks. Correct the position of the
washer and screw thread if
appropriate.
The intake hose for cold water is not
suitable for connection to a hot water
connection.
Switching to cold water operation
If the washing machine is not
connected to a hot water point, you will
have to configure the settings
Main
wash water , Prewash water , and Rinse
water to cold (see “Supervisor level”).

Unscrew the hot water hose.
 Screw on the stopper provided.
Maintenance
Only use genuine Miele Hoses that have
been tested to withstand pressure of at
least 7,000 kPa (1,015 psi) should you
ever need a replacement.
A filter is located in the open end of
the intake hose and another in the
intake point to protect the water
intake valves.
Neither filter may be removed.
Hose extension
Longer hoses of 2.5 m or 4.0 m (8.2 ft
or 13 ft) in length are available from
Miele Service or from your Miele dealer
as accessories.