Miele MasterCool K 2601 Vi, Инструкции по эксплуатации и монтажу

Страница: 37 / 108

Building in the appliance
37
Pushing the appliance into the
niche
Then push the appliance into the
niche, taking care not to damage the
electrical connection!
If you are installing several appliances
side by side, now secure the appli-
ances to one another (see the instruc-
tions for the side-by-side installation
kit).

Remove the toe-kick board

from
the appliance toe-kick as follows:

Carefully guide a flat-head screw-
driver through the grate in the toe-
kick board

on both sides and use
it to push the internal plastic latches
outwards to release the toe-kick
board.
5
6
 Affix edge protection  to the adja-
cent cabinet fronts.

Insert the plug connector at the back
of the appliance (see “Electrical con-
nection”).

Insert the plug

into the electrical
outlet.
The electrical outlet should be close
to the appliance and easily accessi-
ble!
Otherwise, it must be possible to
switch the appliance on and off us-
ing an external all-pole switch with a
sufficient contact gap!

Risk of short circuit and over-
loading!
When installing appliances side by
side, each appliance must have its
own dedicated electrical outlet.
Tip: Secure the power cord to prevent it
becoming caught: Tie a piece of string
to the middle of the power cord and as
the appliance is being pushed into the
niche, pull the cord forward underneath
the appliance.
 Carefully push the appliance into the
niche.
 If the appliance cannot be pushed
into the niche (because the floor is
uneven, for example), unscrew the
rear feet slightly (see “Aligning the ap-
pliance”) and slide the appliance into
the niche.
 Remove the edge protection  from
the adjacent cabinet fronts.