Operation
75
Display of programme duration
The estimated duration of the selected
programme appears in the display
before the programme starts. If the door
is opened during the programme, the
time left until the end of the programme
is displayed.
The displayed duration may vary for the
same programme. It is influenced by,
for example, the temperature of the
incoming water, the reactivation cycle
of the water softener, the detergent
type, and the amount of dishes and
how soiled they are.
When a programme is selected for the
first time, the display will show the
average programme duration for a cold
water connection.
The programme durations shown in the
“Programme chart” refer to standard
test loads and temperatures.
Each time a programme is run, the
control module calculates the
programme duration depending on the
temperature of the water taken into the
dishwasher and the size of the load.
Starting a programme
If necessary, confirm the previously
displayed message with
OK
.
Start the programme by closing the
door.
The in-operation indicator light comes
on to show that a programme has been
started.
Risk of scalding due to hot
water.
During operation, water in the
dishwasher may be very hot.
Only open the door if absolutely
necessary and exercise extreme
caution when doing so. Before
closing the door again, leave it ajar
for approx. 20 seconds. This will
enable the temperature in the wash
cabinet to settle.
Содержание G 7969
