Problem solving guide
102
Fault in the AutoDos (automatic dispensing)
Problem
Cause and remedy
The message
Insert PowerDisk or
deactivate AutoDos with OK
appears in the display.
The
AutoDos
function is active but no PowerDisk has
been inserted.
Insert a PowerDisk (see the “Detergent” chapter,
“Automatic dispensing/AutoDos” section).
If you do not wish to use automatic dispensing,
deactivate the function using
OK
.
The optical in-operation
indicator light is
flashing quickly.
The alarm tone is
sounding.
The programme does
not start or a
programme that has
already started stops.
The message
AutoDos lid
open
appears in the
display
The AutoDos lid has not been closed properly.
Close the AutoDos lid and lock it fully (see
“Detergent” chapter, “Automatic dispensing/
AutoDos” section).
If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see “Detergent”
chapter, “Inserting a PowerDisk” section).
If the same fault message appears again, call the
Miele Customer Service Department.
The message
PowerDisk empty.
Deactivate AutoDos with
OK.
appears in the
display.
The
AutoDos
function is active and the PowerDisk is
empty.
Replace the PowerDisk (see the “Detergent”
chapter, “Automatic dispensing/AutoDos” section).
If you do not wish to use automatic dispensing,
deactivate the function using
OK
.
The message
PowerDisk empty.
Deactivate AutoDos with
OK.
appears in the
display even though you
have inserted a new
PowerDisk.
The dishwasher was switched off when the
PowerDisk was replaced and it has therefore not
recognised the new PowerDisk.
Switch the dishwasher on before replacing the
PowerDisk (see the “Detergent” chapter,
“Automatic dispensing/AutoDos”, “Inserting a
PowerDisk” section).
Содержание G 7960 C SCVi
Страница 122: ......
Страница 124: ...M Nr 11 708 140 03 en SG G 7960 C SCVi ...