Programme options
57
Signal tones
A sequence of signal tones will sound
at the end of the programme or if there
is a fault.
The signal tones at the end of a
programme and the alarm tone in the
event of a fault will sound 4 times at
intervals with a short pause between
each set.
The signal tones are switched off as
standard.
You can switch on the signal tones that
sound at the end of a programme if you
wish. The alarm tone that sounds in the
event of a fault is always switched on.
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the
button in and,
while
holding it in
, switch the dishwasher
on using the
button.
Keep the
button pressed in for at
least 4 seconds until the
indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the
programme selection
button 4 times.
The top left programme indicator light
will flash rapidly 4 times at intervals.
The flashing sequence in the time
display indicates whether the signal
tones at the end of the programme are
activated or deactivated:
-
: Signal tones are activated
-
: Signal tones are deactivated
Press the
button to change the
setting.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
Содержание G 5481
