This appliance must be built in,
otherwise it could tip up.
Location
The appliance should be installed in a
dry well ventilated room.
The room temperature should not go
above or below the climate range for
which the appliance is designed. The
higher the ambient temperature of the
room, the more energy the appliance
requires to operate. It should not be in-
stalled where it is exposed to direct
sunlight or directly adjacent to a
heat-producing appliance such as an
oven or a radiator.
Climate range
The appliance is designed for a partic-
ular climate range (ambient room tem-
perature), and should not be used out-
side this range. The climate range of
this appliance is stated on the data
plate inside the appliance.
Climate range
Ambient room
temperature
SN, N
ST
T
to +32 °C
to +38 °C
to +43 °C
The appliance will function perfectly
down to a temperature of +5 °C.
Ventilation
Air at the rear of the appliance gets
warm. The appliance housing unit must
be constructed to allow sufficient space
for ventilation. Miele kitchen units are
designed to provide this ventilation.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance for air to circulate.
The air inlet to the appliance is via the
plinth in the housing unit.
The cross section of the air inlet and
outlet must be at least 200 cm
2
to en-
sure that air can circulate without hin-
drance. Otherwise the appliance has to
work too hard resulting in an increase in
electricity consumption and damage to
the compressor.
The air inlet and outlet must not be
covered or blocked in any way.
They should be dusted on a regular
basis.
Before installation
^
Before installation remove the sealing
strip etc. from the outside of the ap-
pliance and take any accessories out
of the inside of the appliance.
^
Remove any cable clips from the rear
of the appliance.
^
Check that all parts at the rear of the
appliance are unhindered.
Installation
29
