Program settings
113
Drying unit
The additional “Drying” function accelerates the drying process at the
end of the program.
When the drying function is activated and the door is closed, the dry-
ing system feeds heated and HEPA-filtered air into the wash chamber
for active drying of the load. The heated air is discharged through the
steam condenser and can be cooled down if necessary (see “Addi-
tional settings/Air cooling”).
Cooling down
pause
A cooling down pause can be inserted between the end of the final
rinse phase and starting of the drying system. During this pause, wa-
ter vapor is extracted from the wash chamber and condensed by the
steam condenser. This reduces the moisture level in the wash cham-
ber, which promotes drying.
...
Cooling down pause
Cooling down pause
Time
No
-
No
The drying system starts immediately after the rinse phase without
a cooling down pause.
-
Time
The cooling down pause is activated for a duration which can be
set.
Use the arrow buttons
and
to select an option and press
OK
to
confirm your selection.
When
Time
has been selected, the duration of the cooling down
pause must then be set.
Cooling down pause
120
(0 - 600
s
s)
The setting value is entered in increments of 10. The possible range is
shown in the bottom line of the display.
Use the arrow buttons
(higher) and
(lower) to set the duration
of the cooling down pause.
Press OK to save the setting.
