24
Switch the vacuum cleaner on and
select the highest power setting.
Lift the floor brush off the floor a little.
How the FilterBag change indicator
works
The FilterBag change indicator is set for
normal household dust. This generally
contains a mixture of dust, hair,
threads, carpet lint, grit, etc.
However, if the cleaner has been used
to vacuum up fine dust, such as plaster,
brick dust, cement or flour, the pores of
the FilterBag will become blocked very
quickly.
This affects the air permeability of the
bag, and the marker will indicate that
the bag is “full” even when it is not. If
this happens you must still change the
FilterBag because suction power will be
greatly reduced by blocked pores in the
FilterBag.
If, on the other hand, a large amount of
hair and carpet lint which typically con-
tains a lot of air is vacuumed up, the in-
dicator may fail to react even though
the bag is full. You should still change it.
Both these extremes can occur.
Replacing the FilterBag
Press the release buttons at the side
of the hose connector, and remove
the hose from the suction opening.
Lift the release button for the dust
compartment lid and raise the lid until
it engages.
The FilterBag has a closing flap which
closes automatically when the dust
compartment lid is raised to prevent
any dust escaping.
Содержание 5018
Страница 1: ...Operating Instructions Canister Vacuum Cleaner en US M Nr 11 217 140 HS15 ...
Страница 10: ...Appliance description 10 ...
Страница 35: ......