Midian 24DME4H109, Инструкция по установке и эксплуатации

Страница: 10 / 20

the following installation procedure must be carried out by a qualified electrician.
For the installation of the cable carry out the following operations:
1. Open the terminal board by inserting a screwdriver into the side tabs of the power
code cover. Use the screwdriver as a lever by pushing it down to open the cover as below:
Electrical connection
Power supply voltage and frequency: 220-240V A.C. 50Hz-60Hz.
The electric cooker without a power supply cable. The cooker is designed to operate on an
electricity supply which conforms to the electrical data shown on the Rating label . The
cooker can be connected to the mains only after removing the back panel of the cooker itself
with a screwdriver.
: Note
2. Connect the electricity follows the diagram as printed in the surface of power code cover.
3. Fasten the supply cable in place with the clamp and close the cover of the terminal board.
The red electricity indicator on control panel will illuminate once connect to electricity. Note:
Push
mains
10
Afterv fixing anti-tilt bracket, push the electric cooker inside cabinet as show in Figure 4. For
correct installation, the rear and right foot of cooker would be clipped by the anti-tilt bracket.